0 pts
3 pts
Units: IPS
1 pts
2 pts
4 pts
Planes, Arc Centers, Edges, etc
Tangent, Concentric, Coincident, etc
6 pts
-2 45 deg angled plane -2 1.38 distance to hole -2 D= 0.60" (thru hole) R= 0.75" (same as base width)*
4.50" length (overall)
1.50" wide
0.50" thick
0.5" (edge to center)
Centered in Base (.75)
R= 0.25" (tangency)
1.25" offset
Hole Dia = 0.50" concentric with rounds
R= 0.50" (check for tangency)
5 pts
-1' if sketch is not fully defined -1' if Draft is not used -1' if Shell is not used -1' if unit is not IPS
-1' if sketch is not fully defined -1' if sweep is not used -1' if unit is not IPS
-1' if sketch is not fully defined -1' if unit is not IPS -1 check - 1.29", 0.29", 30 deg