0 pts
2 pts
4 pts
5 pts
2' extrude depth=global variable L, L is changeable with different values 2' fillet all edges R=0.03 1' fillet two corners concentric with two holes, R=0.25 (extrude cut also could work for these two corners)
1' fully defined sketch horizontal dist=0.25, 0.62, 0.12 vertical dist=0.62, 0.85, 1.6, 2.5 -1'/missing dimension, up to 5'
2' two hole cut dia=0.25, fully defined 1' slot cut vertical dist=1.25, 2' slot cut horizontal dist S is defined by an equation
2' use linear pattern for slots with correct direction 3' number=8, spacing=0.12+S
change total distance L, the spacing between cuts change together, the thickness T stays 0.12
-1' if start point (1.3/.80) is wrong -1' if sketch (top) is not fully defined -1' if model geometry is wrong -1' if unit is not inch
-1' 0.54 counterbore depth -1' hole pattern -1' if model geometry is wrong -1' if unit is not inch
-1' if no helix used -1' if no sweep feature used -1' if model geometry is wrong -1' if unit is not millimeter
Finish all homework problems