iRubric: DT I_HW#2a Grading rubric

edit print share Copy to my rubrics Bookmark test run assess... delete Do more...
DT I_HW#2a Grading DT I_HW#2 Grading Rubric Code: U2X73X5 Ready to use Public Rubric Subject: Engineering Type: Homework Grade Levels: Undergraduate

Fig 2.1 Vise Plate Descriptions 4.44 %
	No Credit 0 pts	No 0 pts	Yes 2 pts
Units (inch) 2 pts -2 if units are not IPS	No Credit	No	Yes
Fig 2.1 Vise Plate 22.22 %
	No Credit 1 pts	Fair 3 pts	Good 5 pts
Sketch References 5 pts planes, arc centers, edges, etc	No Credit	Fair	Good
Sketch Relations 5 pts Tangent, Concentric, Coincident, etc	No Credit	Fair	Good
Fig 2.1 Vise Plate 40 %
	No Credit 0 pts	No 0 pts	Yes 2 pts
Base 2 pts 1.75 length	No Credit	No	Yes
Base 2 pts 0.50 thickness	No Credit	No	Yes
Base 2 pts 1.0 thickness	No Credit	No	Yes
Base 2 pts 1.0 offset	No Credit	No	Yes
Base (full round) 2 pts 1.76 width (check for tangency)	No Credit	No	Yes
Slot, R.25 2 pts .5 (to center)	No Credit	No	Yes
Slot, R.25 2 pts R=.25 (tangency)	No Credit	No	Yes
Slot, R.25 2 pts .88/centered	No Credit	No	Yes
Thru Hole (.63 dia) 2 pts hole dia = 0.63	No Credit	No	Yes
Other Problems 33.33 % No dimension check, only check if the sketch has correct geometry and is fully defined
	No Credit 0 pts	Fair 3 pts	Good 5 pts
Fig 2.2 Taper Cap 5 pts -1' if sketch is not fully defined -1' if unit is not IPS	No Credit	Fair	Good
Fig 2.3 Tooling Block 5 pts -1' if sketch is not fully defined -1' if unit is not IPS	No Credit	Fair	Good
Fig 2.4 Clip Handle 5 pts -1' if sketch is not fully defined -1' if unit is not IPS	No Credit	Fair	Good