iRubric: DT I_HW#2 Grading rubric

edit print share Copy to my rubrics Bookmark test run assess... delete Do more...
DT I_HW#2 Grading DT I_HW#2 Grading Rubric Code: A2X62W4 Ready to use Public Rubric Subject: Engineering Type: Homework Grade Levels: Undergraduate

Fig 2.1 Vise Plate Descriptions 6 %
	N/A 0 pts	No 0 pts	Yes 3 pts
Units (inch) 3 pts Units: IPS	N/A	No	Yes
Fig 2.1 Vise Plate 16 %
	Poor 1 pts	Fair 2 pts	Good 4 pts
References 4 pts Planes, Arc Centers, Edges, etc	Poor	Fair	Good
Relations 4 pts Tangent, Concentric, Coincident, etc	Poor	Fair	Good
Fig 2.1 Vise Plate 12 %
	Poor 2 pts	Fair 4 pts	Good 6 pts
Sketches 6 pts All sketches must be fully constrained	Poor	Fair	Good
Fig 2.1 Vise Plate 36 %
	N/A 0 pts	No 0 pts	Yes 2 pts
Base 2 pts 1.75" length	N/A	No	Yes
Base 2 pts 0.50" thickness	N/A	No	Yes
Base 2 pts 1.0" thickness	N/A	No	Yes
Base 2 pts 1.0" offset	N/A	No	Yes
Base (full round) 2 pts 1.76" width (check for tangency)	N/A	No	Yes
Slot, R.25 2 pts .5" (to center)	N/A	No	Yes
Slot, R.25 2 pts R=.25" (tangency)	N/A	No	Yes
Slot, R.25 2 pts .88" (Centered)	N/A	No	Yes
Thru Hole (.63 dia) 2 pts Hole Dia = 0.63"	N/A	No	Yes
Other Problems 30 % No dimension check, only check if the sketch has correct geometry and is fully defined
	No Credit 0 pts	Fair 3 pts	Good 5 pts
Fig 2.2 Taper Cap 5 pts -1' if sketch is not fully defined -1' if unit is not IPS	No Credit	Fair	Good
Fig 2.3 Tooling Block 5 pts -1' if sketch is not fully defined -1' if unit is not IPS	No Credit	Fair	Good
Fig 2.4 Clip Handle 5 pts -1' if sketch is not fully defined -1' if unit is not IPS	No Credit	Fair	Good